Joined
·
2,244 Posts
Hmm, that was a post from long ago. No, I do not have the dimensions. Sold those adaptors . They seemed to work only in Polish manufacture magazines. I also tried converting magazines to short blanks. Had moderate success with a feed ramp block made of brass, cut to fit inside the front of magazine feed channel with a ramp shaped to fit. Pinned in place with a roll pin. Steel on brass has certain lubricity so the noses of blanks slid up ramp well. Problems encountered were exact feed angle through trial and error plus variance in the blanks themselves.
The pans would hang up on last 2 or 3 rounds usually. Otherwise worked pretty well. But a LOT of effort to get it right. The adapters I sold worked much better. Good luck !
The pans would hang up on last 2 or 3 rounds usually. Otherwise worked pretty well. But a LOT of effort to get it right. The adapters I sold worked much better. Good luck !