Gunboards Forums banner

IMR 4007sc ?s

2K views 3 replies 4 participants last post by  MR 8x57 js 
#1 ·
Bought an 8lb jug of IMR 4007sc. Have been a big fan of 4064 for years, but my dealer was out and it was the closest he had on hand. I am sure the short cut will make for much nicer and more accurate metering. I am not finding a whole lot of data for this powder in milsurp calibers. I would like to use it in 8mm Lebel, 6.5 Swede, Japanese, and carcano as well as .308 and 8mm mauser. I would also like to know if it is a safe powder to "throttle back" with in light loads and cast BULLETS with. Anyone have any experience with it ? I have been reloading for over 20 yrs now, but have never cared much for experimenting with loads. Thanks.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top