Gunboards Forums banner

Dixie Gun Works Tower Pistol

987 views 4 replies 3 participants last post by  dcriner 
#1 ·
Just picked up a tower pistol from Dixie Gun Works at a recent gunshow. Want to disassemble it to clean it up a bit. Does anyone know how the barrel comes off? Got the tang screw off but the barrel must be pinned in the stock somehow but I can't figure out how. I do not see a hole in the stock where a pin would go through. Any advice would be appreciated.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top